Set motion detection from Camera interface or Netcam?

Before I begin setting up a couple cameras in Netcam I had a question. The cameras are a foscam that has an SD card and a Dahua that does not. when it comes to setting up the motion detection should I do that on the camera or in Netcam? Or is it both only if you want to record to the SD card and to the HD? Thanks.

I recommend that you set up motion detection only in Netcam so the videos are stored on the HD. I think that is the best and easiest way where you also use all the features of Netcam Studio. If you must have the videos from motion detection stored on the cameras SD card you must also configure the camera for motion detection with storage on the SD card.