Is there a possibility to configure this camera on Netcam studio X?
There is no driver for it in “Brand” field.
Webcamxp support sent me to this forum
Is there a possibility to configure this camera on Netcam studio X?
There is no driver for it in “Brand” field.
Webcamxp support sent me to this forum
Hi,
This camera ? http://www.media-tech.eu/MT4095en
This is a USB camera so when you add this to NCS go to tab Local Source / Webcam. Windows should find and load the driver for the camera so you should see it in the field Source. If you don’t see it there it might be a 32-bit driver for the camera. Then you need to use the 32-bit version of NCS. Test also with some other software like Skype if the camera works there.
Good luck and please report back how it goes.
-Henrik
That was sort of different .
According to the specifications the camera support the ONVIF standard. When you add this one to NCS use the tab for ONVIF Source.
-Henrik
I tryied to, but it is not working:frowning:
After click browse - camera had been found. I tape Username and Password, try click Get Profiles, but there is no reaction.
If I try to click Accept (tick symbol) nothing happend at all
OK, problems in paradise
Do the following:
-go to tab for Custom URL
-set stream type to rtsp_tcp
-in Address use
rtsp://username:password@cameraIP:554/live/ch0
test also with ch1.
-Henrik
Briliant! Works great!
Thank you very much!